Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Burien Homeowners
A broken garage door spring brings the whole door down hard – often with a bang loud enough to hear from the kitchen – and leaves you stuck with a car you can’t move. We repair broken, worn, and mismatched torsion and extension springs in Burien, and we treat high-tension spring work as a core specialty rather than something to hand off. Our technicians have up to 15 years of experience and work on what you already own, diagnosing the actual failure before recommending anything. We offer same-day service when you call, free estimates, and a price you agree to before any work starts. Call (877) 542-9430.
What Our Garage Door Spring Repair Service Includes
We handle the spring work that many generalists decline or quietly outsource, and we handle it as a defined specialty rather than a sideline.
Torsion Spring Replacement
Torsion springs are the coiled springs mounted on the shaft above the door, and they do most of the lifting work on a standard sectional door. When one snaps – usually at the end where the coil fatigues – the door becomes dangerously heavy and the opener strains or fails trying to lift it. We remove the failed torsion spring and replace it with one matched to your door’s weight and height, then balance the door so the opener isn’t fighting excess load.

Extension Spring Replacement
Extension springs run along the horizontal tracks on each side and stretch as the door closes, which is why they’re the older and, when they fail, the more violent of the two designs. When they wear out they can let go suddenly, so we always pair replacement with proper safety hardware rather than just swapping the coil. We replace extension springs as a matched pair and check the pulleys and cables they attach to while we’re in there.

Broken Spring Repair
A snapped spring usually leaves the door halfway up or fully down with a very obvious gap in the coil, and the door won’t move smoothly in either direction. We confirm the break with a visual inspection and a lift test rather than guessing from the sound, then replace the failed spring and test the full travel before we leave. If only one spring of a pair has broken, we’ll explain why replacing both at once usually makes more sense than waiting for the second one to go.

Spring Adjustment
Springs that are still intact but set too tight or too loose make the door feel heavy, slam at the bottom, or reverse before it closes. We adjust the tension to match the door’s actual weight so the door holds its position when you let go halfway up – the standard test for a properly balanced door. Adjustment is often the right call when the springs are sound and the problem is balance, not breakage.
Safety Cable Installation
Safety cables run through the center of extension springs so that when a spring breaks, the pieces are contained instead of flying across the garage. If your extension spring setup doesn’t have them, or if the existing cables are frayed or loose, we fit new cables as part of the repair. This is one of the least expensive things you can do to make an older spring system safer.
Spring Inspection
A spring inspection looks for the small warning signs that predict a failure before it happens – a stretched coil, a gap at the winding cone, rust at the anchor point, or a door that’s started to feel heavy. We check both torsion and extension setups and tell you plainly whether you’re looking at a soon-to-fail spring or a system with plenty of life left. If your springs are fine, we’ll say so and leave you with a clear picture of what to watch.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
Springs aren’t usually branded, but the doors and openers they’re attached to are, and knowing how a specific make is built changes how we diagnose a problem. We service Raynor doors and know how their torsion setups and track hardware are put together, which helps when a Raynor door’s spring tension needs to be matched to its specific panel weight. We also work regularly on LiftMaster and Chamberlain openers, where a dying spring shows up first as an opener that strains, reverses, or trips its safety sensor logic. Genie systems get the same treatment, including the older chain-drive models where a heavy door accelerates wear on the rail and gear assembly.
None of that means we sell you a particular brand or push one over another. We work on what you already have – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, or Raynor – and we diagnose by how that equipment actually behaves rather than reaching for a generic fix. Whether you have a Raynor torsion system or any other make, we can help.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. A torsion spring breaking sounds like a gunshot or a heavy weight dropping, and it usually means the spring has snapped at one end. If you heard that sound and the door won’t lift, stop trying to open it and call – the door is now dead weight on a strained opener.
- The door feels extremely heavy when you lift it by hand. A balanced door should lift with one hand and stay put halfway up. If it feels like lifting a garage’s worth of weight, the springs have lost tension or failed, and forcing it stresses the opener and the door’s frame.
- A visible gap in the spring coil. Look at the torsion spring above the door or the extension springs along the tracks. A clear gap or a section that’s stretched and separated means the spring is broken and needs replacing before the door is used again.
- The door goes up crooked or stops halfway. Uneven spring tension on one side makes the door bind and rise at an angle, which can bend panels and pull the door off its tracks if you keep running the opener. This usually points to a spring that needs adjustment or replacement.
- The opener strains, reverses, or the door slams down. An opener that labors, trips its safety reverse, or lets the door drop fast at the bottom is often compensating for weak or unbalanced springs. Catching it here can save the opener’s motor and gears.
Our Garage Door Spring Repair Process – Step by Step
- 1
Phone diagnosis and scheduling. We ask what happened, what kind of door you have, and whether you heard a bang, so we can bring the right springs and tools. We offer same-day service when you call and confirm the visit window up front.
- 2
On-site inspection and balance test. On arrival we inspect both the torsion and extension setups, check the cables and drums, and do a manual lift test to confirm the door’s actual weight and balance. We’re looking for the real failure, not just the obvious one.
- 3
Written estimate before any work. We explain what broke, what we recommend, and give you a written price before anything is touched. The written estimate sets the final price – you agree to it before we start, so there’s no surprise on the invoice.
- 4
Safe spring replacement. High-tension spring work is performed by technicians trained specifically for it, using winding bars and proper containment so the stored energy in the spring is controlled at every step. We replace matched pairs together and fit or check safety cables as needed.
- 5
Balance test and clean-up. After the new springs are in, we cycle the door several times, set the tension, and confirm it holds position and reverses correctly. We test the opener against the repaired door and leave the garage clean.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Burien?
A typical garage door spring repair in Burien runs $180 – $340 for one spring. That range covers the common scenarios: replacing a single broken torsion spring, replacing one extension spring, or adjusting and rebalancing a spring that’s still intact but out of tune. Because springs are usually replaced as a matched pair, a pair costs about twice that range. Here’s how the line items typically break down:
| Service | Typical Estimated Range |
|---|---|
| Spring Repair (one spring) | $180 – $340 |
| Matched pair of springs | about twice the single-spring range |
| Cable Repair (if cables are frayed) | $130 – $250 |
| Opener Repair (if the opener was strained) | $120 – $320 |
What affects the price: whether it’s a torsion or extension setup, whether one spring or a pair is replaced, door height and weight, and whether the cables, drums, or opener need attention alongside the springs. To avoid overpaying, get a written estimate before work starts and ask whether the price covers both springs if yours are a pair. Our free estimate includes the inspection, the balance test, and a clear written price – and the estimate is the price.
Garage Door Spring Repair Near Burien – Our Service Area
We connect homeowners with local professionals across Burien and the surrounding area, including White Center, SeaTac, Tukwila, Bryn Mawr-Skyway, Des Moines, Vashon, Renton, Mercer Island, and Kent. Response times vary by location and how busy the day is, but we offer same-day service when you call and confirm the window up front. If you’re in a nearby city, you can also read about garage door spring repair for the SeaTac area.
Serving Burien, WA – Our Local Coverage Area
We serve Burien and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Burien
Garage door spring repair is the replacement, adjustment, or rebalancing of the torsion or extension springs that counterbalance your door’s weight. It matters because the springs do most of the lifting – when they fail, the door becomes dangerously heavy and the opener can’t safely move it. At Burien Garage Door Repair Pros, we handle both torsion and extension spring work in-house, including the high-tension side that many generalists decline. Call (877) 542-9430 for a free estimate.
Most spring repairs take about an hour to an hour and a half on site, depending on whether it’s one spring or a pair and whether cables or opener issues need attention. We confirm the window when you call and offer same-day service when scheduling allows. The written estimate covers the scope, so you know what to expect before we start. Call (877) 542-9430 to book a time.
Garage door spring repair in Burien typically runs $180 – $340 for one spring, and a matched pair costs about twice that range because both are usually replaced together. Cable repair, if needed, runs $130 – $250, and opener repair runs $120 – $320. Your written estimate sets the final price and is agreed before any work starts. Call (877) 542-9430 for an exact quote – estimates are free.
Yes, we service LiftMaster and Chamberlain systems along with Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. We know where these systems tend to wear – like a LiftMaster opener that strains when a spring weakens, or a Genie chain drive that labors against an unbalanced door. We work on what you already own and don’t push a replacement. Call (877) 542-9430 to describe what’s happening.
Yes, we offer same-day service when you call, and we take broken-spring calls seriously because a snapped spring leaves the door unsafe to operate. If you heard a bang and the door won’t lift, stop using the opener and call us – we’ll get you scheduled and confirm the window. We also work with your insurer if the failure ties into a broader claim. Call (877) 542-9430.
We stand behind the spring work we perform and will explain the coverage on your specific repair in the written estimate before any work begins. Because the estimate is written and agreed up front, you’ll know exactly what’s covered and what isn’t. If something isn’t right after the repair, call us and we’ll make it right. Call (877) 542-9430 with questions about your job.
Clear the area under and around the door, move cars out of the garage if you can, and don’t try to force the door open or closed – a door on a broken spring can drop suddenly. Have your door’s make and rough height handy if you know them, which helps us bring the right springs. Then leave the rest to us. Call (877) 542-9430 to schedule.
Schedule Your Garage Door Spring Repair Service in Burien Today
A broken spring doesn’t fix itself, and forcing the door only risks the opener and the door frame. Call Burien Garage Door Repair Pros at (877) 542-9430 for a free, no-obligation estimate on garage door spring repair, with same-day service when you call and a written price agreed before work starts. We also handle garage door opener repair if the spring took the motor with it, and you can learn more about our full range of work at Burien Garage Door Repair Pros. Homeowners in nearby White Center can read about garage door spring repair there as well.
Written by the team at Burien Garage Door Repair Pros.